Asteriod collector continues to collect when it appears to be disconnected from the control network (however it is displayed as connected) and appears to be full.
- 10-29-2024, 20-37-51.png (1.3 MiB) Viewed 791 times
1. An Asteriod collector is not connected to the circuit network - it says it is disabled, however continues to collect asteriods (up to a certain point)
2. The inventory of the asteriod collector seems to be full, however I can click on the inventory to move an asteriod into the platform hub and the empty slot immediately gets filled, this can happen 6 times before the empty space in the inventory is visible.
3. After clicking once the asteriod and emptying 1 apparently invisible slot, the collector will collect one asteroid again.
Steps Taken before this:
1. Connect collector to control network, toggle set filters & read contents & enable_disable (condition left as default)
2. Disconnect the asteriod collector from the network
(I have tested this was repetable on my save - available on request)
