Stevetrov encountered this desync removing and placing down an EEI on a server. Looks to be an issue with the active entity order. I managed to figure out a way to semi reliably reproduce it.
Steps to reproduce
1. Paste the attached blueprint on a new server in the editor
2. Wait until it starts outputting circuits, then leave the server and join again.
3. Remove the EEI in the top right corner of the blueprint and put it down again. You might have to do this a few times before it desyncs.
[boskid][1.1.33] Desync on power loss and restore
-
Hornwitser
- Fast Inserter
- Posts: 214
- Joined: Fri Oct 05, 2018 4:34 pm
- Contact:
[boskid][1.1.33] Desync on power loss and restore
- Attachments
-
- desync-blueprint.txt
- (190.36 KiB) Downloaded 154 times
Re: [boskid][1.1.33] Desync on power loss and restore
Thanks for the reproduction steps, i was able to find the cause of those desyncs and the issue should be now fixed for 1.1.34. This desync was caused by improper fix for 96457 which would wakeup inserters in non deterministic order when beacons change their broadcasted effects due to lose of power. For now i reverted fix for 96457.