[1.1.49] Stack inserters don't insert into assemblers with a full output

[CousinJack]

While creating a very fast green circuit production module I noticed that my inserters weren't inserting properly, they would stop inserting when the output of the assembler was full. This wouldn't be a problem if it was a lower throughput build but as each assembler is producing 15 circuits a second this creates a bottleneck only fixable by adding an unnecessary extra assembler.

You can reproduce this bug by creating this setup:

Screenshot 2021-12-13 213910.png (159.04 KiB) Viewed 828 times

The input inserter will stop inserting once the 'Output full' status is shown.

Thanks for reading

[Loewchen]

viewtopic.php?f=23&t=54355