[2.1.9] Nuclear reactor sends wrong fuel signal

[jackthesmack]

I built a new nuclear reactor and after some wiring setup, the reactor outputs an additional 1 fuel than what's inside. If empty, it outputs 1. If 1 is in, it outputs 2.

These are the steps I did before:

1. Built Reactor
2. Inserter put in 6 fuel
3. Added circuit to restrict fuel
4. Told bots to remove all fuel from reactor
5. Noticed issue

Not sure if the bots removing the fuel caused a problem. Save is attached

Discord_GtweR3zYZ8.png (108.27 KiB) Viewed 180 times

Discord_rfHXmsPZRc.png (92.43 KiB) Viewed 180 times

Discord_DvX4Fa7k3r.png (167.55 KiB) Viewed 180 times

[Tertius]

You get 2 because 1 fuel cell is currently burning and 1 fuel cell is in the input slot.