- 11-14-2025, 16-47-21.png (504.14 KiB) Viewed 267 times
The behavior changes depending on where you build it too:
- 11-14-2025, 16-55-02.png (683.19 KiB) Viewed 267 times
[2.0.72] Rail Signals do not split blocks in half-diagonal rails
-
NotRexButCaesar
- Smart Inserter
- Posts: 1140
- Joined: Sun Feb 16, 2020 12:47 am
- Contact:
[2.0.72] Rail Signals do not split blocks in half-diagonal rails
As you can see, although I have a crossing with four signals, one on each end, the left side is still one block, despite the fact that at the crossing I can see the block being split into two pieces.
The behavior changes depending on where you build it too:
The behavior changes depending on where you build it too:
Ⅲ—Crevez, chiens, si vous n'étes pas contents!
-
NotRexButCaesar
- Smart Inserter
- Posts: 1140
- Joined: Sun Feb 16, 2020 12:47 am
- Contact:
Re: [2.0.72] Rail Signals do not split blocks in half-diagonal rails
I don't think this is the same because this is on straight rails and those are on curved rails. I saw those when searching before I made this.
Ⅲ—Crevez, chiens, si vous n'étes pas contents!
Re: [2.0.72] Rail Signals do not split blocks in half-diagonal rails
F4 --> show-rail-segment-collision-boxes
The boxes overlap in the Magenta area; ergo they are the same "block".
Good Luck!
- 11-14-2025, 20-56-19.png (579.92 KiB) Viewed 217 times
Good Luck!
-
NotRexButCaesar
- Smart Inserter
- Posts: 1140
- Joined: Sun Feb 16, 2020 12:47 am
- Contact:
Re: [2.0.72] Rail Signals do not split blocks in half-diagonal rails
I understand the reason why this is happening, I just think this is wrong. At least the graphics for this situation are incorrect, given that the two blocks are not shown as connected.
Ⅲ—Crevez, chiens, si vous n'étes pas contents!