[2.0.72] Rail Signals do not split blocks in half-diagonal rails

NotRexButCaesar · Post by **NotRexButCaesar** » Sat Nov 15, 2025 12:55 am

: 11-14-2025, 16-47-21.png (504.14 KiB) Viewed 265 times

As you can see, although I have a crossing with four signals, one on each end, the left side is still one block, despite the fact that at the crossing I can see the block being split into two pieces.

The behavior changes depending on where you build it too:

: 11-14-2025, 16-55-02.png (683.19 KiB) Viewed 265 times

Post by **Loewchen** » Sat Nov 15, 2025 1:07 am

116415 and 117435

NotRexButCaesar · Post by **NotRexButCaesar** » Sat Nov 15, 2025 1:12 am

Loewchen wrote: Sat Nov 15, 2025 1:07 am 116415 and 117435

I don't think this is the same because this is on straight rails and those are on curved rails. I saw those when searching before I made this.

eugenekay · Post by **eugenekay** » Sat Nov 15, 2025 1:58 am

F4 --> show-rail-segment-collision-boxes

: 11-14-2025, 20-56-19.png (579.92 KiB) Viewed 215 times

The boxes overlap in the Magenta area; ergo they are the same "block".

Good Luck!

NotRexButCaesar · Post by **NotRexButCaesar** » Sat Nov 15, 2025 4:03 am

I understand the reason why this is happening, I just think this is wrong. At least the graphics for this situation are incorrect, given that the two blocks are not shown as connected.

Factorio Forums

[2.0.72] Rail Signals do not split blocks in half-diagonal rails

[2.0.72] Rail Signals do not split blocks in half-diagonal rails

Re: [2.0.72] Rail Signals do not split blocks in half-diagonal rails

Re: [2.0.72] Rail Signals do not split blocks in half-diagonal rails

Re: [2.0.72] Rail Signals do not split blocks in half-diagonal rails

Re: [2.0.72] Rail Signals do not split blocks in half-diagonal rails