[2.0.45] Parameters in display panel messages do not work when connected to a circuit network

[Vashu]

Since 119866 it is possible to use parameters in display panel messages.
But this only works if the display panel is not connected to a circuit network.
As soon as a circuit network is connected, parameters in messages no longer work.

Not sure if this is a bug or intended, but i would expect the circuit connection to have no impact on parameter usability.

Steps to reproduce:

1. Configure a display panel with a message that contains parameters
2. Connect the display panel to a circuit network.
3. Parameters in messages are no longer parsed or replaced.

See also attached video, which first shows working behavior without circuit network connection and then attaching a power pole leading to parameters in display panel messages no longer working.

[tinker9]

Seems similar to viewtopic.php?f=7&t=126117