Since there are currently quite some bugs reports concerning smart belts, I was wondering what is currently the best way I should report those bugs:
- file one new report with all "new" bugs I can find (like I did here)
- file a new report for each different bug (that would mean 5 reports instead of this one)
- append to existing reports (like the 2 I mentioned in this report)
I would be glad to know what helps you the most!
Now to the actual report:
In each picture, the top row is the layout of belts before I drag a belt between the loaders.
I then copied this setup four more times and dragged a belt in the height of the loader. Each time, I would expect one continuous new belt (with undergrounds where necessary) while all belts placed before remain the same. A working example of this can be seen in Case 1, last row.
Each of those rows has a different orientation and direction of the belt drag. The orientation of the belt is the same as the orientation of the loader in the row and I start the drag next to the loader. That means:
The first row is after I dragged right-facing belt from left to right.
The second row is after I dragged right-facing belt from right to left.
The third row is after I dragged left-facing belt from right to left.
The fourth row is after I dragged left-facing belt from left to right.
The save file is attached.
Case 1:
1st and 4th row as expected, 2n and 3rd row broken
- 1.PNG (86.78 KiB) Viewed 156 times
1st and 4th row as expected, 2n and 3rd row broken
- 2.PNG (103.67 KiB) Viewed 156 times
all rows broken
- 3.PNG (60.29 KiB) Viewed 156 times
1st and 4th row as expected, 2nd and 3rd row broken
- 4.PNG (52.03 KiB) Viewed 156 times
1st and 4th row as expected, 2nd and 3rd row broken
- 5.PNG (95.37 KiB) Viewed 156 times