Does "Quality" Make Fusion Reactors Worse?

[mmmPI]

[Moderated by Koub : response to a since then moderated post]

That's not how power generation is met. You've already said accumulators aren't necessary (I'm obsessed with them apparently.) I would absolutely love to see how you're going to build your power set up that keeps fusion reactors at 100% output while having solar, steam, fission, or whatever supplying the remaining demand... without accumulators.

send blueprint of your posted setup, i will gladly upgrade them to higher quality to show you

[mmmPI]

Can you spot the worst setup ?
Which one is the most efficient ?
Why do you think people are answering you are wrong when you say quality make fusion worse ?

spot the worst setup.jpg (343 KiB) Viewed 153 times

[spacedog]

The power draw of those are all different.

The question isn’t “how much power does your factory have to use in order to get a specific neighbor bonus”.

The original post is complaining that for any given power draw, different quality reactors result in different neighbor bonuses, which impacts efficiency.

While that’s true, it’s just not what the devs optimized for. They optimized for more power in a smaller footprint. Probably because, like nuclear power, it's so trivial to produce more fuel cells than you can ever use that efficiency just doesn’t matter.

This is starting to remind me of that massive thread about optimizing nuclear reactors so they don’t waste fuel cells. If that’s a fun puzzle to solve then go for it, but it doesn’t have any practical real world applications. It’s more like a contest to achieve the pinnacle of premature optimization.

[mmmPI]

The original post is complaining that for any given power draw, different quality reactors result in different neighbor bonuses, which impacts efficiency.

The original post ask if "quality" make fusion reactor worse , and if something was missed by its author, it's unclear it was posted only to complain, but last time i suggested it was the case you said it wasn't helping much the discussion. ( and was moderated )

The previous setup illustrate probably something that was missed given the other example setup shown.

The question isn’t “how much power does your factory have to use in order to get a specific neighbor bonus”.

Just a reminder that the original post mention a scenario :

If you do encounter a scenario where your max load is greater than your max output, it's by far easier and more efficient (with higher max productivity bonuses) to add more normal quality reactors than it is to add quality reactors.

This is what i showed in my setup.

Edit : i show a setup where max load is greater than max output.
the "far easier and more efficient" is not what i show i'm asking the question

[Orum]

No , they have the same efficiency when they have the same neighbour bonus and same 100% output (and they produce more power for the same footprint ! )

But they won't have the same neighbor bonuses! That's what I've been saying this entire time: for any given power output, as long as it's more than a single normal reactor can provide, you will have higher neighbor bonuses and thus higher efficiency with lower quality reactors.

This is what i showed in my setup.

So you finally agree that lower quality reactors are more efficient?

[mmmPI]

So you finally agree that lower quality reactors are more efficient?

No , they have the same efficiency when they have the same neighbour bonus and same 100% output (and they produce more power for the same footprint ! )

Which part of the quotation make you think i agree with your statement ?