Shift + Mouse up/down only cycles blueprint names, not the actual blueprints

[gmmf]

When I hold shift and scroll the mouse wheel while holding a blueprint book, only the names of blueprints in a book are cycled, the shown blueprint stays the same at all time.
I am not 100% sure when this first happened, but I think it was after updating from 1.1.8x to 1.1.92. Now I updated to 1.1.94, and this is still broken

before shift scrolling

Bildschirmfoto_2023-12-09_17-57-03.png (131.76 KiB) Viewed 454 times

after shift scrolling

Bildschirmfoto_2023-12-09_17-56-47.png (143.53 KiB) Viewed 454 times

[Loewchen]

Cannot reproduce, even with the same bp book. Post a vanilla save and exact steps to create the issue, see 3638.