Signals based on train "not working" for some items

[dewitpj]

Hi Guys,

I have the following setup:

Screen Shot 2020-03-05 at 08.30.23.png (980.95 KiB) Viewed 2712 times

Now with some items, when a train is *not* present, the item is still being sent to the network:

Screen Shot 2020-03-05 at 08.30.30.png (402.49 KiB) Viewed 2712 times

Some items, appear to work "normally":

Screen Shot 2020-03-05 at 08.30.35.png (378.85 KiB) Viewed 2712 times

I remember spotting this change in around 0.17 if I remember correctly. I expect that the items are reported based on the train content and when the train leaves it reports nothing.

Thanks !

[Loewchen]

Post the save that shows that behavior.

[dewitpj]

As requested

[dewitpj]

Post the save that shows that behavior.

It uses the electric train mod but this doesn't have an impact on the "bug"

[boskid]

Not a bug

81974.png (34.32 KiB) Viewed 2690 times

[dewitpj]

Not a bug
81974.png

Hi,

I am not sure I see how you got to that - why is it telling the inserter (green network) to load walls when there is no train present ? While the guns one, to the left of that "works correctly" ?

[dewitpj]

Not a bug
81974.png

To a degree I can see how this "works" - no signal is less than 100 but that doesn't explain the gun one ?

[boskid]

Not a bug
81974.png

To a degree I can see how this "works" - no signal is less than 100 but that doesn't explain the gun one ?

In case of a gun there was "output: input count" so condition was true and on output there was 0 since thats what was on input.

[dewitpj]

Not a bug
81974.png

To a degree I can see how this "works" - no signal is less than 100 but that doesn't explain the gun one ?

In case of a gun there was "output: input count" so condition was true and on output there was 0 since thats what was on input.

I could have sworn I tested that too - retested and that gives the result needed - sorry about that

[dewitpj]

Not a bug
81974.png

To a degree I can see how this "works" - no signal is less than 100 but that doesn't explain the gun one ?

In case of a gun there was "output: input count" so condition was true and on output there was 0 since thats what was on input.

Ah - I think I spotted why I didn't think this worked at the start - the problem with doing it this way is if the train is empty it doesn't return anything.

So my question then is, is the only way to do this to use an arithmetic gate to convert NULL to some high value ?