deactivated inserter does not stop

[tex443]

Hey,
I know it is not a bug, but may be unwanted behavior?

If an inserter cannot load its load completely into the wagon, it loads the rest into the next wagon even after deactivation.

Screenshot

screen.PNG (253.33 KiB) Viewed 528 times

In my case I can prevent this by pinning the items in the wagon, but that is no nice solution.

Any suggestions?

Regards,
Tex

[Optera]

The vanilla loading controller I built back in 2016 should still work: viewtopic.php?f=194&t=28268&start=80#p182483
A few posts down you can also see how much using my Inventory Sensor cuts down on circuitry.