What I did:
I was playing the introduction campaign and did what you asked, I broke it.
What happened:
Whilst building my expansion to the right of the starting area, I had researched turrets.
I build a few and took all the bullets I made and wondered if I could clear out the biters right then and there.
I placed two a little ways apart and started to kite the biters between them, behind me.
Everything died nicely.
I had no more bullets my self all were placed in the turrets.
I then accidentilly picked up a radar I had in my inventory and pressed Q to put it back and at the same time tried to pickup a turret.
The radar then went in to the place where my bullets were ment to go and the game just stopped.
What I expected to happen:
I was expecting the bullets to go into my bullet slot and my radar to go into my inventory.
I have had this happen once and have not been able to reproduce it. (sorry)
Hope this helps
[0.17.0] Game Crash when using turret during introduction campaign
[0.17.0] Game Crash when using turret during introduction campaign
- Attachments
-
- screenshot
- crash.jpg (270.22 KiB) Viewed 820 times
-
- factorio-current.log
- log file
- (17.61 KiB) Downloaded 68 times
-
- _autosave1.zip
- last save
- (3 MiB) Downloaded 64 times
Re: [0.17.0] Game Crash when using turret during introduction campaign
Duplicate of 65339
I'm an admin over at https://wiki.factorio.com. Feel free to contact me if there's anything wrong (or right) with it.