[16.5] Crash on Inserter::draw() when pole is picked up

[iguessthislldo]

Crash first occurred when I was using the deconstructor in the toolbar on the whole miner/smelting setup that I'm at. However by trial and error I narrowed it down to a particular medium power pole that I'm hovering over with my cursor in the attached screenshot.

The crash occurs when using the robots or taking it by hand without removing anything else. The crash will occur if the connected power pole to the right is removed first but not if either of other two (north or west) are taken first. The crash will occur if the smelters and inserts that it covers are taken first. None of the other poles being removed will crash the game as far as I can tell.

No mods were active in this game.

[Unboxious]

I may have just had the same thing happen to me.

[Adventium_]

I have just had this crash too (took me a while to confirm that it was the same crash, but I am pretty sure it is).

Was working on a simple assembly line for power medium and big lighted power poles (added with a mod). While the assembly line was running, I was holding wooden power poles and removed a power pole to change where it was going to be placed, and Factorio crashed.


Save file:

.16HYPE.zip

(4.37 MiB) Downloaded 74 times

Log file:

factorio-current.log

(24.23 KiB) Downloaded 82 times

Mods folder:

mods.zip

(4.2 MiB) Downloaded 74 times

[ToddTM]

This looks like me too.

[posila]

Thanks for the report.
This has been fixed for 0.16.6: 55176