Chain signal not updated after changes
Chain signal not updated after changes
I have a chain signal which operates fine. After I start modifying the tracks sometimes it goes red. If I remove the tracks that made it red signal remains red although it should go back to green. If I remove the chain signal and add it again at the same spot under same conditions it now is green (as expected).
- Attachments
-
- Went red during changes on tracks - should go back to green now but it doesn't.
- Screen Shot 2017-05-12 at 16.50.33.png (1.86 MiB) Viewed 1280 times
Re: Chain signal not updated after changes
Post the save with the signal in the incorrect state please.