Burner inserter can't grab coal properly
-
- Filter Inserter
- Posts: 252
- Joined: Wed May 13, 2015 5:28 am
- Contact:
Burner inserter can't grab coal properly
This Burner inserter burnt itself out.
The yellow belt was outputting coal from a single Electric Miner on the inside lane of the belt.
The Burner Inserter would reach for it, but it would get out of reach to quickly for it to grab it.
Re: Burner inserter can't grab coal properly
Known behaviour for inserters grabbing from corners.
Re: Burner inserter can't grab coal properly
I'm a bit lost here, what is the inserter supposed to do at that position in the first place?
-
- Filter Inserter
- Posts: 252
- Joined: Wed May 13, 2015 5:28 am
- Contact:
Re: Burner inserter can't grab coal properly
The pieces of coal going past were spending too little time in the Burner Inserter hitbox preventing it from refueling itself, and the boiler I replaced the pipe with.
It can't grab it but attempts to regardless. Using up the 1 coal value of fuel from when they're placed down.
It can't grab it but attempts to regardless. Using up the 1 coal value of fuel from when they're placed down.
Re: Burner inserter can't grab coal properly
If you move the coal to the outside of the curve it will work, or just put the vertical feed one tile further west.
NaB
NaB