When sending the spidertron through the fog of war with a remote and looking at the map, the line is not shown in the not-pixelated part of the map, if the remote is no longer selected in the cursor whilst still being visible in the pixelated part of it. As soon as I "take" the remote into the cursor again it is shown in both parts again. It also vanishes again when deselecting the remote by pressing Q.
What would I expect?
The visibility of the remote path should be consistent on both the pixelated and not-pixelated part of the map.
[1.1.37] Spidertron remote path line not shown properly on map
-
Anders142536
- Burner Inserter
- Posts: 8
- Joined: Mon Nov 23, 2020 11:12 pm
- Contact:
[1.1.37] Spidertron remote path line not shown properly on map
- Attachments
-
- strike against.zip
- save file
- (21.48 MiB) Downloaded 86 times
-
- factorio-current.log
- (75.29 KiB) Downloaded 86 times
-
- fogofWar3.png (238.41 KiB) Viewed 1049 times
-
- fogOfWar2.png (15.33 KiB) Viewed 1049 times
-
- line is gone in non pixelated part of map
- fogOfWar.png (336.82 KiB) Viewed 1049 times
Re: [1.1.37] Spidertron remote path line not shown properly on map
I am not considering current behavior to be a bug. In chart rendering the spider paths are rendered always (if you have access to given spider) to give you a better overview of what is happening, while in the normal mode it draws path only for currently selected spider. What you see here is just a case where part of map is rendered as normal and part is rendered as chart. There is more such transitions like recipe icons on a border will be cut, map tags will not render text outside of chart ("pixelated area") etc.