"Use these settings next time" for blueprint size and snap

[5thHorseman]

TL;DR

There should be a "Use these settings next time" for blueprint size and snap, to make creation of blueprint sets easier.

What ?

There should be a "Use these settings next time" for blueprints, if you have enabled size the size/snap options. Enabling this will make the next blueprint you make after this one have those same settings enabled, including this option.

For example, if you make a rail blueprint that is 84x84 with snap enabled, and you check "use next time", then the next blueprint you make (which is likely the Nth one of this rail set you're making) will automatically be 84x84 with snap enabled. I don't expect to be able to nail the center flag each time, so that can default to center or edge or whatever it does now.

Why ?

When I am making a blueprint of an exact size and with snap on, I'm for sure making a set of them. This set will always have the same settings, and it's a bit of a pain to do it manually every time. This would alleviate that.