tl;dr can I configure where UI elements go on my wide resolution?
What I've observed:
- on 5760x1080 (Nvidia Surround via three 1920x1080 displays), the left and right-most UI elements are all the way at the left and right edges of my displays respectively i.e., the stuff on the left is basically absolutely positioned at x = 0 and the UI elements on the right are positioned at a negative x location (bear with me if that was confusing)
- config.ini doesn't appear to have any way to specify the repositioning of the UI elements
- there was an Options modal that contained a WYSIWYG (e.g., draggable/resizeable rectangle representing the constraints of UI elements)
- constraints (maybe not the width or height but at least the x and y positions) could be configured from the user's config.ini
- swiveling my head around so much might cause undue wear and tear on my spine but if all the UI elements were, for example, placed on the center monitor of a 3-monitor setup, you would be able to gather all the information you need without turning your head and use the adjacent displays for peripheral vision (the stuff happening on the map anyway)
- folks with weird displays like 47" 21:9 displays or an arbitrary number of displays via Surround/Eyefinity could tighten-up their UI to extend their spine longevity