Opened Locomotive interface and waited for station to be active.
What happened?
Station name didn't color white from red, and destination of the train was set to this station.
What did you expect to happen instead? It might be obvious to you, but do it anyway!
Station name should color to white from red, and destination set to this station
Steps to reproduce:
Have two stations, one if offline (B), second is online (A).
Make train go from A -> B
Timer to cycle the station B
When you open the interface and wait station B to cycle it status, status won't be updated until you close locomotive interface and open it again.
On image below you can see that train is going to "inactive" station, but if I reopen the interface the station will be white
image
