[0.155] Oil LOading

[busterle123]

Dear guys,

this is my first question so i hope u can help me

I don´t understand how to load liquid oil into the new liquid trains.
i tried to do it with a pump but i failed.

thx a lot.

bye bye

Phil

[Kelderek]

The pump must be directly beside the track pointing at the wagon (for loading) or away from the wagon (for unloading). Run pipe on the other side of the pump to the oil source or destination. Make sure the pump(s) have electricity. When a train pulls up you will see a visual of an arm reaching to the top of the fluid wagon to connect, this way you know you set it up correctly.

[busterle123]

I do not understand why does it sometimes works and sometimes not...

[Kelderek]

Can you post a picture of a place where it isn't working for you?

[Shokubai]

Do you have a stockpile to load....say a couple of full storage tanks to pump from? If you are trying to put from nothing but pipe without some sort of reservoir you are only going to get what tiny amount is in the pipe and nothing more.

Pump In.png (488.12 KiB) Viewed 2881 times

Here i have 2 tanks to hold petroleum gas.

Then the secondary question becomes....are you producing enough?

[orzelek]

For really fast loading you can use something like this:

pumps.png (203.9 KiB) Viewed 2828 times

It can pump out both tanks to tanker in few seconds. The key for this to work is that pump needs to be attached directly to tank.
Middle pump in this arrangement might not be needed.

[The Eriksonn]

A problem is that it is very hard to align when driving manually as you have to be very precise.

A funny thing is that if you hit the very end of the track it lines up...

[orzelek]

I'm pretty sure it's not meant for manual driving. With automated train it always aligns as it should.

Any particular reason why you drive your tanker manually?