Upon clicking "Set", it will correctly assign a negative, and display correctly on the Summary GUI, however, upon bringing up the configuration GUI again, the hyphen is once again not visible.
- negative 1.PNG (577.76 KiB) Viewed 2947 times
[14.22] Combinator does not display hyphen in Signal selection UI
[14.22] Combinator does not display hyphen in Signal selection UI
When setting an arithmetic combinator, the "Or set a constant" box does not display anything when you type a hyphen.
Upon clicking "Set", it will correctly assign a negative, and display correctly on the Summary GUI, however, upon bringing up the configuration GUI again, the hyphen is once again not visible. This was not an issue in 0.13, and appears to be a regression introduced at some point in 0.14.
Upon clicking "Set", it will correctly assign a negative, and display correctly on the Summary GUI, however, upon bringing up the configuration GUI again, the hyphen is once again not visible. This was not an issue in 0.13, and appears to be a regression introduced at some point in 0.14.
Re: [0.14.22] Arithmetic Combinator does not display negatives
Works fine for me. Please post your log file to see what system you use.
screenshot
Re: [0.14.22] Arithmetic Combinator does not display negatives
Log file attached.
- Attachments
-
- factorio-current.log
- (2.63 KiB) Downloaded 155 times
Re: [0.14.22] Arithmetic Combinator does not display negatives
I am using the same character. U+002D HYPHEN-MINUS (ASCII 45)
Re: [14.22] Combinator does not display hyphen in Signal selection UI
Can't reproduce the issue.
Keep in mind that that the slider goes from 1 to 2000000000, in case you are moving the slider.
Keep in mind that that the slider goes from 1 to 2000000000, in case you are moving the slider.