Not sure if this belongs here or in the technical help.. I'm just trying to understand the game mechanics involved here. With this setup:
The assembly machine on the bottom, gets nearly all the activity. The top one will occasionally empty a barrel, but not often. During a short test (ie. limited data) the ratio seemed to be about 10 to 1. What is happening here? Is there a set default to favor fluids from the south direction or something?
Fluid behavior / Oil flow
Fluid behavior / Oil flow
Professional Curmudgeon since 1988.
- ChurchOrganist
- Filter Inserter
- Posts: 256
- Joined: Sun Apr 17, 2016 12:45 pm
- Contact:
Re: Fluid behavior / Oil flow
I've been wondering that too.
I have a similar setup for oil but oriented E/W rather than N/S
The W assembler empties more oil than the E despite both assemblers having their own output pipe to the 4 storage tank array, and the path the oil takes being longer for the W assembler than the E.
I have a similar setup for oil but oriented E/W rather than N/S
The W assembler empties more oil than the E despite both assemblers having their own output pipe to the 4 storage tank array, and the path the oil takes being longer for the W assembler than the E.
Want to know where the biters chewing your power plant have come from??
Wondering where your next iron is going to come from??
You need Long Range Radar
Wondering where your next iron is going to come from??
You need Long Range Radar
Re: Fluid behavior / Oil flow
And thinking about it... a related question: What is the throughput capacity? Is an Assembly Machine 3 able to on it's own fill the throughput capacity of a pipe assuming complete usage on the other end?
Professional Curmudgeon since 1988.
Re: Fluid behavior / Oil flow
Depends on how far you're sending the crude, and how well that single red inserter can keep putting full barrels into the assembler. You might be able to slightly bottleneck with both machines going full tilt, but not by much, I wouldn't think. And if that turns out to be the case under full production, just doubling the pipe would likely fix things easily enough.
That said, the electric pump you have in the picture will completely cap fluid flow at 30 units/second, which one assembler can definitely provide on its own.
Try erasing and replacing the pipes out of each assembler in turn, see if that changes the liquid flow priority at the T-junction. Fluid mechanics can be weird in this game.
That said, the electric pump you have in the picture will completely cap fluid flow at 30 units/second, which one assembler can definitely provide on its own.
Try erasing and replacing the pipes out of each assembler in turn, see if that changes the liquid flow priority at the T-junction. Fluid mechanics can be weird in this game.
Re: Fluid behavior / Oil flow
The pump limits the flow? Without it the capacity is higher? Weird.
Professional Curmudgeon since 1988.
Re: Fluid behavior / Oil flow
Yeah, pumps can boost flow to 30 units/second, but that's a hard cap. So if your flow would have been higher, the pump actually hurts, and if you want higher, you need to use multiple pumps in parallel with each other. Personally, I would leave the pump out unless you get problems later on. If you got time to burn, feel free to take a look at this thread, with a bunch of numbers to consider.