[0.12.35] Big electric poles doesn't get connected

[Progman]

Hi,

When building big electric poles via a blue print sometimes the connection to the neighbor big electric poles are not made when the robots place the big electric pole. The savegame is attached. Check the following screenshot:

Pole does not get connected with neighbor

bug_big_electric_poles.jpeg (421.03 KiB) Viewed 1672 times

The big electric pole in the top right is in range to the other poles, however it doesn't get connected. The pole to the left and to the bottom (from the pole in the top right) is in some kind of invalid state. When you try to place a big electric pole manually near these two poles the preview doesn't show a connection. You even see a missing link from the pole on the left (from the player) to the pole on the bottom left (from the player). In fact, a lot of my big electric poles doesn't have a full connection to all 4 neighbors. I can fix the states of these invalid poles by simply rebuilding them, where they get connected to all four neighbors again.

When I load/migrate this savegame with 0.13.6 the error state of the poles still exists, even though it would be a good time to resets all the poles state during the migration. Again, if I rebuild the poles in version 0.13.6 the error is gone as well.

[kinnom]

power poles have a maximum of five connections

[Loewchen]

power poles have a maximum of five connections

Indeed.
NaB.