[0.13.0] PowerSwitch logic crash
-
tdimdimich
- Manual Inserter

- Posts: 2
- Joined: Wed Jun 29, 2016 9:18 pm
- Contact:
[0.13.0] PowerSwitch logic crash
I test using power switch with logic for enable steam engine, when accumulator is low
- Attachments
-
- factorio-current.log
- log
- (3.41 KiB) Downloaded 192 times
- Klonan
- Factorio Staff

- Posts: 5527
- Joined: Sun Jan 11, 2015 2:09 pm
- Contact:
Re: [0.13.0] PowerSwitch logic crash
Thanks for the report,
does this issue persist in 0.13.1?
If it does can you provide some steps to reproduce the crash, and a savegame file where we can easily test it?
Also some screenshots or gifs of the crash would be really helpful too
does this issue persist in 0.13.1?
If it does can you provide some steps to reproduce the crash, and a savegame file where we can easily test it?
Also some screenshots or gifs of the crash would be really helpful too
-
Loewchen
- Global Moderator

- Posts: 10962
- Joined: Wed Jan 07, 2015 5:53 pm
- Contact:
Re: [0.13.0] PowerSwitch logic crash
What was happening when it crashed? What were you doing at that time?
- YSX
- Burner Inserter

- Posts: 14
- Joined: Fri Nov 28, 2014 5:21 am
- Contact:
Re: [0.13.0] PowerSwitch logic crash
Same problem, occurs in 0.13.1 too.
It happens then I try connect power switch to logic or logistic network. Or sometimes it connects, but then network conditions changes, and crash happens.
It happens then I try connect power switch to logic or logistic network. Or sometimes it connects, but then network conditions changes, and crash happens.
- Attachments
-
- factorio-current.log
- (13.53 KiB) Downloaded 210 times
Poor english speaking russian translator =D
-
NorwegianBlue
- Burner Inserter

- Posts: 19
- Joined: Fri Jul 01, 2016 12:54 pm
- Contact:
Re: [0.13.0] PowerSwitch logic crash
I got this same problem in 0.13.2 -- this was a game started fresh in 0.13.0
When the logic state changed, turning the power switch off - crash.
I reloaded the save, and tried again and it was fine. Ran through many cycles with no issue.
When the logic state changed, turning the power switch off - crash.
I reloaded the save, and tried again and it was fine. Ran through many cycles with no issue.
- Attachments
-
- _autosave3.zip
- (10.86 MiB) Downloaded 183 times
-
- factorio-current.log
- (6.33 KiB) Downloaded 203 times
-
kovarex
- Factorio Staff

- Posts: 8298
- Joined: Wed Feb 06, 2013 12:00 am
- Contact:
Re: [0.13.0] PowerSwitch logic crash
I fixed power switch reconnection logic, most probably fixes this as well for 0.13.3