video attached below
What did you do?
super force printed a blueprint (see attachment) on a bunch of belts.
What happened?
It removed some belts that weren't covered by the blueprint (between the steel power poles and the inserters)
It is also inconsistent (or seemingly so) in when it removes the belts
What did you expect to happen instead? It might be obvious to you, but do it anyway!
I would expect it to either:
- not remove the belt that is not covered by the blueprint, or
- to behave consistently in when it removes the belt
Does it happen always, once, or sometimes?
It seems to always happen
blueprint:
[2.0.77] super force print unneccessarily removes belt (and inconsistently?)
[2.0.77] super force print unneccessarily removes belt (and inconsistently?)
- Attachments
-
- 2026-08-08 17-33-48 - Kopie.mp4
- (53.11 MiB) Downloaded 24 times