Power Poles should show Circuit Network ID

[JackTheSpades]

Any device (inserter, assembler, belt, etc) connected a circuit network will show what ID they are connected to... except power poles.
If you are trying to make a compact setup with wires going to and fro it would be nice to know what network a power pole is actually connected to.
Or more like, is there a real reason not to show it? Is the code not fit to handle it?

ID shown on inserter

grafik.png (31.78 KiB) Viewed 105 times

ID not shown on power poles

grafik.png (178.42 KiB) Viewed 105 times

[sben]

see also 123661