Allow quality range conditions in circuit conditional GUIs

[protocol_1903]

TL;DR

Allow the quality range setting seen on inserter and splitter filters to be used in circuit control GUIs, like decider and arithmetic combinators, enable/disable circuit settings, etc.

What?

I would like to use the :any-quality:, >, <, =, >=, <=, ~= quality evaluators inside of signal evaluation conditions like those found in combinators. GUI example:

Untitled123.png (53.29 KiB) Viewed 191 times

Why?

I want to be able to evaluate multiple qualitied signals simultaneously. While I can do this using selector combinators, having 'inline' per se support would make certain operations a lot cleaner, and it would help some composite entities I'm designing that need to deal with quality in very specific ways

[Koub]

[Koub] Merged into an older thread with the same suggestion.

[protocol_1903]

These are not fundamentally the same suggestions, please decouple them

[Koub]

These are not fundamentally the same suggestions, please decouple them

Okay, they seemed pretty similar to me though.
[Koub] Resplit both suggestions.