Train "Circuit" Conditions Require "Send to Train" Enabled

[Ranec1]

When setting train schedule you can trigger on a circuit value. If a train station does not have the "Send to Train" option enabled, which requires a red/green wire, the train is halted. The check seems to fail no matter the condition.

If no signals are present I would expect it to interpret that as a zero, just as other parts of the circuit network behave since "null" is not valid and no other system halt as far as I am aware.

---

Below is a simple test I setup. It has two small tracks. The only difference is connecting a red wire to the lower stop "A".

Code: Select all

0eNqVmNGOmzAQRf9lnmEVY2wCb+039G0VRSSxdi0RQOCkjSL+vYYozbYbbe99QoDnDMll5COusmtOrh98G6S6it937SjV61VG/9bWzXytrY9OKhlq38iUiG8P7pdUatok4trgg3e3iuXksm1Px50b4oLkXhliaZuOoeslkb4bY0nXzuQZo3UiF6lSlZsIP/jB7W+3VZbIGOrbiXyLrT+1yP60GOceb+8hXZ7yqy767y75E6zGsYbA5ji2ILAGx5YE1sLYXBHYAscyka1xLBNZiWOZyNQK5zKZKQVzDROawgfNMKkpfNIME5vCR81QueGzZqjc8GGzVG74tFkqN3zcLJUbPm+WyS3D580yuWX4vBVMbhk+bwWTW6axPfkBVf9AP27J359uyR9G71g3TeqaWDz4fdp3jXu2Ka1e7q+IXr+Y6RnTkCqhy88qEcUmDF2z3bn3+uy7YS5aaNuZ1rvD9mE84dLPzc5+CKd6/tfvv2hZkf6Q+JT/dRPLy4kugAwL3k4g7prXE4hb8n6CcPWKFxSIq3hDgbgZrygQV/OOAnFz3lEgruEdBeJa3lEgbsE7CsRd844CcUveURBuvuIdBeIq3lEgbsY7CsTVvKNA3Jx3FIhreEeBuJZ3FIhbkI6izdeOsknkZ7w7f6N4jXaikqgTahOv+uCOccnj+0ciZzeMS6GxWZmXZTzoUls9Tb8BR/6Q2g==

I then have a double headed train with the schedule as shown. It looks for a signal to be zero and moves to the "B" station then returns after a second.

04-04-2025, 15-28-12.png (1.98 MiB) Viewed 106 times

The top train will never move. The bottom train will move back and forth.

[Loewchen]

123385