- 11-07-2024, 15-22-22.png (15.66 KiB) Viewed 197 times
[Kovarex] [2.0.14] parameterizing blueprints do not show affected trains in tooltip
[Kovarex] [2.0.14] parameterizing blueprints do not show affected trains in tooltip
Hey there. when creating a simple blueprint with a train station, a train and some other things, the train will not be visible in the following tooltip during parameterization:
Last edited by GottZ on Thu Nov 07, 2024 3:01 pm, edited 2 times in total.
Re: [2.0.14] parameterizing blueprints do not show affected trains in tooltip
on that note, I also noticed combinator groups are neither listed nor affected.
would be fun if they were added too, so blueprints could have settings based on already defined groups.
(if group already exists -> don't override it's contents, otherwise, create it as it was intended in the bp)
how could this be useful?.. imagine creating a blueprint of a single combinator placed into the world that has all these groups attached to it already, basically defining the groups ahead of printing the blueprint.
in that case it would make total sense to have parametric group switching.
edit:
so.. ye. apparently param 0 added to param groups or group names doesn't do anything.
would be fun if they were added too, so blueprints could have settings based on already defined groups.
(if group already exists -> don't override it's contents, otherwise, create it as it was intended in the bp)
- 11-07-2024, 15-42-13.png (11.78 KiB) Viewed 191 times
in that case it would make total sense to have parametric group switching.
edit:
so.. ye. apparently param 0 added to param groups or group names doesn't do anything.