[2.0.11] Super force building belts over existing belts uses only one bot

[Barblegarb]

Scenario: Super force building a blueprint or copied set of belts over an existing line of belts. For example, super force building a blueprint for splitting one belt off of your main bus.

Expected Behavior: All Construction Robots would be utilized until the entire removal and replacement operation is done.

Actual Behavior: All Construction Robots are used initially, but the number of active robots quickly drops to one. So you may have 10 more belts/entities that need to be removed or replaced, and only one bot is going back and forth to finish the job while the others have already returned to your inventory.

This happens every time while super force building over existing belts.

Example in picture below. I super force built a blueprint over the existing belt bus on the right side. After a few belts were removed/replaced with all 20 bots active, most of them returned to my inventory. Only two were active during the screenshot, and immediately after the screenshot was taken, one of the two remaining bots returned to my inventory, leaving only one bot to finish the last ~5 operations.

screenshot.jpg (451.59 KiB) Viewed 316 times

[Genhis]

Hello, please attach a save file when reporting issues like this.