[2.0.11] Modules not showing in planner totals

[NIronwolf]

I had just built up miners (75) on an ore patch and wanted to verify that I had not missed putting modules (Quality 1) in each miner. I used Alt-D to make a quick Decon planner and highlighted the area. Somehow, it showed 153 Quality 1 modules in the total. I was very confused where the extra 3 modules could have come from since it correctly reported 75 miners. I grabbed a stack of modules and tried control-clicking on some other entities like belts and power poles knowing it shouldn't take them. After a few error beeps I grabbed a decon planner again and highlighted the area. Now, NO modules get tallied. If I make a copy planner it will tally up the miners, but not the modules, however the modules are in the copy. I then tried using copy and decon planners in other areas of the base and modules aren't being tallied anywhere.

I'd expect the modules to show in the tally like they have for years.

Attached log and save.

I tested closing the game and reloading and it seems to still not tally after resuming the save.