This is my science pack setup. Best I've come up with so far. follows the standard 5:6:12 red:green:blue ration for factories. they keep 16 science factories w/ all efficiency research working - after I fixed the smary inserter bottleneck anyway. its fed by a single red belt for copper and iron each (blue corners). 36 steel factories feed each belt.
oh, the boilers are a mod. 4x pollution, 2x heat speed 90% efficient
thoughts? suggestions?
Science Packs
Science Packs
- Attachments
-
- factorio-base.png (4.51 MiB) Viewed 14949 times
Re: Science Packs
if I'm correct, you've got not enough boilers. 14 of them for 10 engines.
- Xterminator
- Filter Inserter
- Posts: 981
- Joined: Sun Jun 15, 2014 4:49 pm
- Contact:
Re: Science Packs
Wow very nice science pack setup! Wish my setups could be that clean and efficient. Hehe
-
- Smart Inserter
- Posts: 1847
- Joined: Sun Feb 23, 2014 3:37 pm
- Contact:
Re: Science Packs
You are correct. 7-10 is not a good ratio.psorek wrote:if I'm correct, you've got not enough boilers. 14 of them for 10 engines.
Re: Science Packs
The boilers are modded - see OP - 7 keeps the engines running just fine.
Re: Science Packs
She is a beauty. Nice build my friend.
Re: Science Packs
Sure; missed that.
Re: Science Packs
thanks. it was the train on the tracks at the end that finally let me run it full tilt. had trouble getting enough circuits to the smart inserter factory before than