Yes I have seen the other related issues, even so this is a rather egregious example.
- 04-26-2026, 22-14-55.png (222.71 KiB) Viewed 322 times
- 04-26-2026, 22-17-06.png (316.28 KiB) Viewed 322 times
[2.0.76] Burner generator does not respect insertion limit
-
protocol_1903
- Filter Inserter
- Posts: 492
- Joined: Fri Sep 09, 2022 4:33 pm
- Contact:
[2.0.76] Burner generator does not respect insertion limit
Bug report: pybugreports
Yes I have seen the other related issues, even so this is a rather egregious example.
Tested on v2.0.76 with experimental pYmods. I'm guessing that it's caused by efficiency not being taken into account. It consumes 5.71MW of power, with each fuel rod having 75MJ of energy. The same issue occurs with the MK05 fuel rods at 550MJ of energy.
See also: 650778, 126909, 124272
Yes I have seen the other related issues, even so this is a rather egregious example.
Tested on v2.0.76 with experimental pYmods. I'm guessing that it's caused by efficiency not being taken into account. It consumes 5.71MW of power, with each fuel rod having 75MJ of energy. The same issue occurs with the MK05 fuel rods at 550MJ of energy.
See also: 650778, 126909, 124272
pY and pYblock developer, wielder of fluid networks and subtick events in arbitrary ways. I make mods. Check them out, maybe.
https://mods.factorio.com/user/protocol_1903
Buy me a coffee
https://mods.factorio.com/user/protocol_1903
Buy me a coffee
Re: [2.0.76] Burner generator does not respect insertion limit
Can i get a save file that i could use to sync mods with and get straight into the reproduction setup to look at?
Re: [2.0.76] Burner generator does not respect insertion limit
Thanks for the report. Issue is now fixed for 2.1.