[2.0.76] Decider combinator shows three parameter in alt view

[Brathahn]

Hello,
i think i have found a graphical bug when you enable "show combinator settings in alt mode" in the interface settings:

2026-02-25 19_05_28-Factorio 2.0.76.png (274.85 KiB) Viewed 179 times

2026-02-25 19_05_42-Factorio 2.0.76.png (85.45 KiB) Viewed 179 times

What did you do?
i placed a decider combinator and "pipetted" the every/any signals into the condition/output fields

What happened?
the alt mode shows that there are three parameters active on the combinator when in alt mode

What did you expect to happen instead? It might be obvious to you, but do it anyway!
i expect the alt view to match the actual setting of the combinator. see screenshots

Does it happen always, once, or sometimes?
happens always, save file and log attached

[boskid]

Thanks for the report. It looks like the drawing is correct as it draws signals that are indeed present on the right side, it is just the gui that refuses to draw those signals since they are not allowed there. For 2.1 i adjusted decider logic to reject special signals on the right side of conditions in cases where they are not allowed (only allowed case is each signal on right when there is each signal on the left).