[Lou][2.0.72] Force stamp doesn't replace modules in editor

[fi5hii]

When force stamping an assembler 3 over an assembler 2 in editor it doesn't replace the modules that used to be in assembler 2 with the ones that are in the force stamp of assembler 3.
Here are the starting two assemblers:

starting.png (673.93 KiB) Viewed 826 times

Then after copying and force stamping this would be the expected result:

expected.png (675.62 KiB) Viewed 826 times

And this is the actual result after force stamping the assembler 3 over the assembler 2:

actual.png (674.16 KiB) Viewed 826 times

This only happens in editor with these construction settings enabled:

Screenshot 2025-10-28 at 01.12.39.png (63.75 KiB) Viewed 826 times

This does NOT happen when out of editor, the ghosts get placed correctly and the modules are scheduled to be removed by bots.
Here's a video of this happening:

force stamp.mp4

(165.65 MiB) Downloaded 165 times

[Lou]

Thanks for the report, fixed for 2.1