[boskid][2.0.68] Upgrade Planner replaces underground belt exit with entrances

[ViperDC]

What did you do?
1. Placed an underground belt entrance and exit in-line.
2. Created a blueprint of this
3. In the "set up new blueprint" screen or opening the blueprint after saving I selected "upgrade items and entities in blueprint" and "default upgrade"

What happened?
Both underground belts are transformed into entrances of the upgraded type

What did you expect to happen instead? It might be obvious to you, but do it anyway!
Underground belts retain their orientation when upgrading.

Does it happen always, once, or sometimes?
If the underground belt can be upgraded (ex. yellow or red) then this occurs every time. Orientation does not appear to matter.

Before upgrade:

Before Upgrade.png (229.16 KiB) Viewed 216 times

After upgrade:

After Upgrade.png (197.41 KiB) Viewed 216 times

Most likely related to:
viewtopic.php?p=681345
But still occurring on 2.0.68

[boskid]

Thanks for the report. Issue is now fixed for 2.0.69.

[pjr]

@boskid has this also been fixed for Deconstruct and then undo? The same issue occurs then.

[boskid]

@boskid has this also been fixed for Deconstruct and then undo? The same issue occurs then.

Are you sure you are experiencing this behavior on 2.0.68? It was present in 2.0.67 and fixed in 2.0.68 by 130977

[pjr]

I was still on 2.0.67. I upgraded to 2.0.68 and now starting factorio causes an OS freeze and crash. I've opened a different ticket.