[2.0.60] Cannot select "Any Quality" within the "Quality Transfer" mode of the Selector Combinator

[dinglebarry]

Selector Combinators should have the "any quality" option under "quality transfer" for both "direct selection" (for circuit contolled filters) and for the "target signal" (for reading items on a belt/chest).

Screenshot 2025-08-22 215154.png (1.87 MiB) Viewed 150 times

This way you would be able to set filters on inserters for multiple qualities. Right now, you are required to set a separate filter for every single quality of every single item which makes it so that you are only filtering one item for all qualities because inserters are limited to 5 filters. It would also allow for you to read how many items of any quality are on a belt. Right now, it would take 5 seprate selector combinators for each quality level to be able to read all items of each quality. You would need to do this for each item type also as the "each" signal does not support quality.

Screenshot 2025-08-22 2159391.png (753.74 KiB) Viewed 150 times

What did you do?
I opened the selector combinator, went to quality transfer, and was not able to select "any quality within the direct selection menu or the target signal menu

What happened?
I opened the selector combinator, went to quality transfer, and was not able to select "any quality within the direct selection menu or the target signal menu

What did you expect to happen instead? It might be obvious to you, but do it anyway!
I expected to be able to select either any quality like on a filter you would apply to a splitter, inserter, etc. or to be able to select greater than, less than, equal to a specified quality like how filters are applied.

Screenshot 2025-08-22 215736.png (891.51 KiB) Viewed 150 times

Does it happen always, once, or sometimes?
Always

[boskid]

Not a bug