[2.0.39] Forced underground belt ghost not placed

[sben]

What did you do? What happened?

1. Copy an underground belt entry part with a pipe in front of it.
2. Super forced build this over a belt line
2.1 before placement, underground belt exit part is shown to be built
3. underground belt exit part ghost did not get placed

What did you expect to happen instead? It might be obvious to you, but do it anyway!

- Super forced build preview differs from the placed ghosts.
- Missing exit of underground belt.

Does it happen always, once, or sometimes?
Always

[sben]

I just had this issue again and saw this post was marked as duplicate.

I think this is not a duplicate and the issue still persist in 2.0.62.

I just searched the forum and did not found any other mentions of this issue (since there are many posts about underground belt ghosts, I might overlooked it) - but I also know that an other underground belt issue I reported was marked as duplicate by fault while it was unique.

[Loewchen]

I think this is not a duplicate and the issue still persist in 2.0.62.

It is a duplicate, it just isn't fixed.