[2.0.58] Cannot super force build rail signal over some belt location

[Brambor]

06-23-2025, 22-11-13.png (476.37 KiB) Viewed 245 times

Cannot super force build a rail signal over the transport belt here:

Belt going right (east)!

06-23-2025, 22-15-28.png (159.05 KiB) Viewed 245 times

If I build a rail signal (or a ghost of rail signal) next to it, I can always super force build:

06-23-2025, 22-17-43.png (171.51 KiB) Viewed 245 times

Reproduction steps:
1. Build two rails (can be just one rail).

Single rail example.

06-23-2025, 22-29-47.png (109.64 KiB) Viewed 245 times

2. Build a transport belt going east.
3. Take a signal and put it over the belt.
4. Super force (ctrl + shift)
5. Click
6. Observe: "Rail signal must be built next to rails" Expected: It is super force built.

Note that in step 3 you MUST NOT hover over the available slot!

In the bug, the rail is not selected:

06-23-2025, 22-24-32.png (151.69 KiB) Viewed 245 times

If you hover over the available slot 1 block east of the transport belt, the rail becomes selected (for the transport belt too):

06-23-2025, 22-26-12.png (164.32 KiB) Viewed 245 times

Note: hovering last over a slot in the opposite direction makes it break again.

06-23-2025, 22-33-48.png (236.83 KiB) Viewed 245 times

In this situation, I can always super force build over the transport belt for some reason.

Belt going left (west)!

06-23-2025, 22-20-01.png (187.23 KiB) Viewed 245 times

[tinker9]

This sounds similar to viewtopic.php?p=673588