[2.0.45]Each Signal Acting as AND instead of OR. Alternatively, Inconsistent behavior

[igorigorigor]

1. What did you do?
- Setup decider combinator as pictured below (A).
2. What happened?
- Combinator outputs a single ("signal-0": 1) as pictured (A).
3. What did you expect to happen instead?
- I expected an additional output of ("signal-1": 2) to also appear on the output.
4. Does it happen always?
- Yes.

Picture A:

04-15-2025, 01-02-48.png (92.67 KiB) Viewed 172 times

1. What did you do?
- Setup decider combinator as pictured below (B).
2. What happened?
- Combinator outputs ("signal-0": 1) and ("signal-1": 2) as pictured (B).
3. What did you expect to happen instead?
- I expected a single output of ("signal-1": 2) to appear on the output. ("signal-0" : 1) should not be there.
4. Does it happen always?
- Yes.

Picture B:

04-15-2025, 01-15-15.png (107.94 KiB) Viewed 172 times

Any help would be greatly appreciated,
Thanks!
-igorigorigor

[boskid]

Welcome on factorio forums. This is s duplicate of 119917 where you will find explanation of why i am not considering this to be a bug.