[2.0.28] Can't connect transport belt with green wire when it's adjacent to a combinator

[xyzzycgn]

Tried to connect a belt with green wire, instead of the chosen transportation belt the adjacent combinator was connected.

The behavior is easy reproducible:

• choose green wire

• try to connect belt and click it

• instead of the belt the combinator is connected

Both arithmetic and decider combinator and both input and output side show this behavior.

[boskid]

Thanks for the report however i cannot reproduce any issues. You seem to have some mods installed, without a save file and reproduction steps there is nothing that can be done.

[Muche]

OP, did you finish connecting the green wire to a target?
Because in that setup (a belt right next to a combinator) it may look like the wire is connecting to the combinator, but it's indeed connecting to the belt.
Connecting a wire to the combinator looks a little bit differently:

GreenWireOnBelt.jpg (273.1 KiB) Viewed 320 times

[xyzzycgn]

OP, did you finish connecting the green wire to a target?
Because in that setup (a belt right next to a combinator) it may look like the wire is connecting to the combinator, but it's indeed connecting to the belt.
Connecting a wire to the combinator looks a little bit differently:
GreenWireOnBelt.jpg

Yep - that's the trick I was expecting that the belt shows a connection immediately after clicking - AFAIR the behavior in V1 - obviously the same happens even without an adjacent combinator

20241225145152_1.jpg (690.61 KiB) Viewed 279 times

20241225145155_1.jpg (691.26 KiB) Viewed 279 times

20241225145159_1.jpg (672.61 KiB) Viewed 279 times

Sorry for the false positive and thx for the quick replies.