I placed a setup that throws iron plates from one furnace directly into another one to burn steel, I did that before I researched steel processing.
now that its researched the inserters don't automatically start putting the plates into the furnaces, they just idle until I refresh them by rotating or replacing them.
[0.11.13] Steel processing research
-
- Smart Inserter
- Posts: 1847
- Joined: Sun Feb 23, 2014 3:37 pm
- Contact:
Re: [0.11.13] Steel processing research
Steps to reproduce:
Set up a steel smelting operation with direct insertion. (It works fine if iron plates are put on belts)
Research steel processing.
The inserter doesn't move iron plates unless replaced/rotated.
Set up a steel smelting operation with direct insertion. (It works fine if iron plates are put on belts)
Research steel processing.
The inserter doesn't move iron plates unless replaced/rotated.
Re: [0.11.13] Steel processing research
Sounds like inserters should be woken up upon new research.
Re: [0.11.13] Steel processing research
Hello, so I managed to fix this issue for 0.11.15