[Genhis][2.0.13] Undo module upgrade does not update GUI

[gaucho]

When undoing a module upgrade from ghost to ghost, the GUI does not update

Step 1: Assembly Machine filled with ghost modules

Step1.png (168.48 KiB) Viewed 998 times

Step 2: Upgrade the modules in remote view

Step2.png (656.76 KiB) Viewed 998 times

Step 3: Click on the machine to open the GUI, and then Ctrl+Z downgrades the modules again, but does not update the GUI

Step3.png (493.34 KiB) Viewed 998 times

Step 4: Closing and re-opening the GUI shows the correct ghost modules (no picture provided)

I provided a save file with the above setup, just in case.

sa_014.zip

(12.18 MiB) Downloaded 14 times

Thanks!

[Genhis]

Thanks for the report, it's fixed for the next release.