[2.0.19] Combinator power consumption in graph is shown inconsistently

[Nolz]

On my space platform, I have a single decider combinator. Opening the power graph with 5s precision shows that it is using 1000 W of power;

11-17-2024, 14-59-28.png (11.25 KiB) Viewed 192 times

Opening the graph with 1m precision instead shows that it is using 1.0 kW of power;

11-17-2024, 14-59-36.png (10.3 KiB) Viewed 192 times

Opening the graph with 10m precision shows it as using 1.0 kW power, but it seems switch to 1000 W for a few milliseconds every couple seconds. The graph seems to always show 1.0 kW when set to 1h precision or higher, except when the satisfaction dropped below 100% at some point, which seems to occasionally cause these graphs to show 1000 W instead of 1.0 kW as well.

I guess this is probably just a precision issue, causing the power consumption to sometimes be off by like 0.1 W. So it sometimes shows the power consumption in watts because it's less than 1000 W, but then the value gets rounded and it ends up showing as 1000 W anyway.

[Rseding91]

Thanks for the report. These values are generated automatically based off how much energy was consumed and stored in a given time window. In one case it's very close to 1000w, in another it's slightly more which auto-formats as 1.0 kw