[Tobias] [2.0.8] rail blueprint default grid snap wrong size with curved-rail-a

[sparr]

1. draw a 90 degree curve with rails (four curved rail pieces)
2. alt+b or ctrl+c then shift, select the whole curve
3. check Snap to grid
4. observe the grid size is 16x16, includes empty space on two sides of the selected entities, and is clipped beyond the frame of the blueprint window

The test blueprint above should be 14x14, include no empty space, and fit inside the edges of the blueprint window.

Further experiments suggest that the blueprint will always extend two tiles beyond the straight end of a curved-rail-a, as if there was a single straight-rail there.

[Tobias1595]

Thank you for the report. The issue has been fixed in the next version.