Train cannot path over specific rail
Whole rail setup build by robots except the station area
https://youtu.be/NDaWBf64UuI
[2.0.13] Train does not path over specific rail
-
martinekopl
- Inserter
- Posts: 21
- Joined: Fri Apr 12, 2019 4:27 pm
- Contact:
[2.0.13] Train does not path over specific rail
Last edited by martinekopl on Wed Oct 30, 2024 9:28 pm, edited 1 time in total.
Re: [2.0.13] Train does not path over specific rail
Your signals are wrong, not a bug.
-
martinekopl
- Inserter
- Posts: 21
- Joined: Fri Apr 12, 2019 4:27 pm
- Contact:
Re: [2.0.13] Train does not path over specific rail
Should, however, those two signals screw up the pathing this much?
-
Mightyloly
- Burner Inserter
- Posts: 16
- Joined: Wed Oct 30, 2024 1:34 am
- Contact:
Re: [2.0.13] Train does not path over specific rail
Flip the two signals at the fork and it'll work as intended.
Yes those two will mess with pathing as it designates that small tiny segment of rail as 'only allow trains to go in *THIS* direction'
If you want rails to be "bidirectional" you'll need signals on both sides
In this case I don't think that is what you are going for.
Yes those two will mess with pathing as it designates that small tiny segment of rail as 'only allow trains to go in *THIS* direction'
If you want rails to be "bidirectional" you'll need signals on both sides
In this case I don't think that is what you are going for.