[2.0.10] Transport Belt replace inconsistencies/glitches.

[xeneonic]

1. Replace these UG with fast UG, by hand, through cursor, no bots or remote view used:

10-25-2024, 17-16-12.png (769.8 KiB) Viewed 214 times

2. Now the UG in my cursor is reversed:

10-25-2024, 17-17-11.png (739.22 KiB) Viewed 214 times

3. But also switching back to the red belt in my cursor (that you see in Picture 1):

10-25-2024, 17-18-03.png (646.05 KiB) Viewed 214 times

In all the three steps, I didn't press a rotate button a single time.

A different glitch, but perhaps related:
A. Filling in the UG part of the BP/ghost, of which the ghost is a normal UG (important part) with a normal UG.

10-25-2024, 17-20-24.png (880.11 KiB) Viewed 214 times

B. Notice the inverted UG again

10-25-2024, 17-21-52.png (948.58 KiB) Viewed 214 times

C. Back to step A, if instead you fill in the yellow UG ghost with a fast UG from cursor by hand:

10-25-2024, 17-23-18.png (900.34 KiB) Viewed 214 times

Unlike in step B, step C fills the UG on both sides.

[Genhis]

I think this is a duplicate of 117222.

[xeneonic]

I would like to argue that step 1, 2 and 3 are not part of that duplicate, but I do agree that A, B and C are duplicates. But if step 1, 2 and 3 are part of the same glitch, then agreed.