[2.0.10] Undoing fast replacement disconnects circuit wires (removes/deletes/undo) (MR)

[Netfire]

If you manually replace a building (e.g. click over a slow inserter with a fast inserter), then undo the replacement, all wires are disconnected

This only occurs if the player character does the replacement; if a construction bot does it, the connections are maintained through the undo (which seems like the intended behavior). This happens when undoing after replacing an item with one of a different tier, with one of a different quality, or with the same item in a different rotation. The rotation one also issues an extra construction bot job when undoing, which isn't done if you overwrite the rotation via the map view or ghost planner before undoing.

Red and green circuit wires are disconnected, and so are wires between power poles

From my testing, this happened with:

• Inserters, belts, power poles, and chests of different tiers
• Chests of different rarities
• Belts and inserters with different orientations

[UraniumAnchor]

Steps to reproduce:

• Have a circuit-connected belt segment
• Fast replace segment with either an underground or splitter, severing the circuit connection
• Undo replacement

Expected:

Belt is restored with the old circuit connection.

Actual:

Belt is restored, but circuit connection is not.

The following two scenarios DO restore the circuit connection, so I would expect the previous to as well:

• Undoing belt deconstruction
• Undoing forced replacement of belt with any other building (I used a substation to test this)

Merged...

[ArEyeses]

I'm noticing this as well in 2.0.15 on inserter quality changes (and presumably all the previously mentioned things as well)
and since this post already exists I'll just add a comment to it.
A few things I noticed:
- the inserter is marked for deconstruction along with a new inserter ghost; the improved behaviour would be marking it as 'upgrade to'.
- when ghost-upgrading (either by holding shift or from map view), undo works correctly.