[0.10.12] Blueprinted smart inserter won't start until poked

[immibis]

A smart inserter which has its condition set, then is rebuilt from a blueprint without keeping its wire connections, will not wake up when the wire is reconnected.

Steps to reproduce:

• Build a test setup, where a smart inserter is wired to something and activated. The exact condition doesn't matter. Example:
  (the smart inserter is moving iron plates from top to bottom, set to red wire condition "copper plates > 1", and there are 2 copper plates in the right chest. The blue inserters are just returning the iron plates so the demonstration keeps running, nothing to see there.)
• Create a blueprint containing only the smart inserter.
• Deconstruct the smart inserter.
• Place the blueprint back where it was. Wait for the robots to build it.
• Reconnect the red wire, so you have exactly the same setup as before.
• Notice that the smart inserter isn't working, even though it should be as the condition hasn't changed.

The smart inserter will re-activate if you touch the condition in any way, even by re-entering the same number into the text field that was already there.

This only happens if the smart inserter's wire connection was not included in the blueprint.

[kovarex]

Thanks for the report.

The inserter now gets alarmed when the circuit connection (the cable) changes.

So it is solved for 0.11.9